Phone & Device Stands: OEM Sourcing Hub

Test at the heaviest supported device weight plus a margin, on a slightly tilted surface, with the device at the most extended angle. A stand that holds a phone at 70 degrees may tip at 45. Ask for a tip-angle and load test, and check the rubber feet: most failures are sliding, not structure.

Enough to hold the device at every angle without drifting, typically a defined torque range measured in kilogram-centimetres. Too much torque makes the stand hard to open; too little and it sags under a tablet. Specify the range plus a cycle test, because cheap hinges lose torque after a few hundred cycles.

Car mounts and foldable desktop stands are the highest-volume formats, followed by tablet stands and vertical laptop docks. Car mounts carry more compliance risk because they interact with vehicles, so confirm the destination market rules before tooling.

Yes. Retail packaging usually needs a printed box with a window or image panel; Amazon needs a compact, drop-tested carton with FNSKU labels. Plan packaging before tooling the product, because a stand that folds flat can cut carton volume significantly and reduce freight cost.

Existing models with a new logo, colour or packaging start at 500 pieces. A new colour or arm length using existing tooling starts at 3,000 pieces. A new body or hinge mechanism starts at 5,000 pieces plus tooling. Mixed formats can share a container if each SKU meets its minimum.